For a long time in Rus’ in baths, they soared not only for carnal purity, but also to strengthen health and spirit. And now in bath procedures many find that they are close in spirit. Many praise the bathhouse as a great way to lose a couple of extra pounds or “fatigue stone” from loaded shoulders.
If you are going to build a bath, then you should figure out what they are. There are only two types of baths among themselves – these are combined and separate types of baths.
Combined baths
Combined baths represent one room with a steam room and a sink. As a rule, such baths are not expensive in construction and compact in size.
With the second type of baths, things are more complicated. The size of the bath and its purpose can fluctuate in a very large range, from a small cozy tribute to a whole bath complex includes a pool, bar, billiards and so on.
At this time, there are two ways to build a bath: frame and timber.
Frame baths
Pros of the frame method of construction:
The construction of the frame takes place in a couple of days and there is no need to shrink. It is obvious that the bathhouse is stronger and in the use of various kinds of isolation materials.
In the construction of a bath using frame technology, different architectural forms can be used. Simply put, you collect a bath as a children’s designer without constraining your imagination.
The frame bath made is good enough and cheaper than a bathhouse from a bar.
Construction of a wooden bath from a bar.
The aesthetics of wooden buildings are fully reflected in the baths from the bar and environmentally friendly materials used in construction speaks for the choice of this construction method. But during the construction of a barbarian bath, you should think over and take into account some points:
The shrinkage of the beam takes place in 1-2 years, and finishing work should be carried out no earlier than this period. And it will not work in this bathhouse right away only if a chipper beam with a smooth and clean surface was not used.
If a beam with a rectangular cross section is used over time, then as a result of loads it is deformed and crack. And you yourself understand the heat in such a bath for a long time will not last.