How to install a laminate? Installation of the laminate is already carried out on a prepared, flat surface explainly placing the substrate, also read the article Laminate.
Let’s check the work of installing the laminate on the floor in the apartment, in the bedroom .
Here is such an option from personal experience, in the bedroom lies the parquet set even during development, but lies relatively even, in this case you can lay the laminate directly on it from the top, or if you want to tear it up, and it is like a prailo on the resin and the layer It can be somewhere small, and somewhere there is a lot and it may also have to pour the screed before the installation, what to say in this case to you.
Above was an option for a random example. That would be the linolium, parquet, etc., The laminate must be installed on the level of 90-100%.
The direction of styling is chosen for you, but you need to do this correctly, depending on the location of the room and windows in the room. Basically, if the room is rectangular, then from the doors from the lion to law, you are standing on the threshold and look into the room.
Also, keep in mind how to put the room or width into the lobe of the room, the sheets of the sheets will be less than waste, and there will be not a few of them in any case.
There are special styling tools. Here is a list of the simplest tools that you will need:
Hammer-medium.
Roulette, quaranlash, corner.
A plank, rectangular not large (attach it to a laminate and beat it with a hammer so as not to break the lock on the laminate).
Electro-lobzik.
Fomka-a we embed it =)? This is a system that is useful when you finish laying the laminate, in the last row, you come to cut the laminate into a lines, since the whole sheet will not get into the rally between the laminate and the wall and your hands of the castle, the fomckee is just “fomka” emphasized the wall and laminate and laminate and The lock is closed ready.
Do not forget that the gap between the wall and the laminate should be explained 1cm, that is, not in dense ksten, it must be observed, but you can put pieces of laminate from waste there, I always do so.
The laminate has 2 locks, 1-in and 2-in, by this in the collected form, it looks like 1 whole.
They did everything, do not forget to put the substrate and moved to the installation:
It will be difficult to collect a laminate alone, you need a partner, an assistant. The first row is collected by transverse locks, followed by 2. 1 person holds a sheet, puts 2 in the castle and so on, everything is very simple. Replacement, auto -glass, or even tinting on Lexus all the glass in stock, the quality is good if you decide to make toning, for example.
When you only inserted the leaf into the castle, it will be at an angle, hit the plane with a hammer with a hammer, the sheet itself is lowered. See carefully that there are no cracks.
Laminate!