Ceiling plinth gives the room a complete, attractive appearance. When using such a plinth, it is necessary to precisely measure its length, paying special attention to corner compounds.
Looking for a good site on which inexpensive noise -protective screens are sold? You can visit this site and choose a good screen there.
1. First you should measure the length of the walls and find out the length of the perimeter of the room to find out the amount of the necessary skirting board. Purchase a plinth with a small margin.
2. Start work with one of the corners of the room. One of the ends of the plinth must be cut at an angle of 45 degrees. It is better to do this with the help of a stir – a special device for cutting at different angles.
3. A piece of skirting boards should be put in a knock and cut one end of the baseboard at the required angle with a knife. The other end of the plinth must be left.
4. Then lubricate the rear surface of the skirting boat with glue. The type of glue depends on the material from which the skirting board is made. By applying the baseboard, it is necessary to remove excess glue with a dry rag.
5. The cut end must correspond to the corner of the room. Since glue dries for several minutes, this time can be used to correct the position of the plinth.
6. The following elements along the entire perimeter of the room should also be glued to the junction. Joints in the seams must be treated with acrylic sealant. 7. Before fixing a piece of skirting boards, first you should try on it, applying to the place of attachment.