The whole increasing amount of work is performed using new equipment – electronic computers. To date, in most design organizations, specialized departments of mechanization of engineering and technical calculations (Omitr) have been created, performing design, sanitary-technical, estimated and other calculations. Computers are mainly used only where it is necessary to produce a huge (from the point of view of manual labor) the number of calculations. Where an engineer can get a solution using a logarithmic line in an acceptable time, he, as a rule, does not resort to the use of computers. If you need to install new water meters, then contact professionals here: a company for installing water meters. In the construction design of computers, they began to use 15-20 years ago mainly to perform static calculations of structures. Computer allowed to sharply increase the labor productivity of engineers engaged in such work. However, this did not significantly affect the general labor costs of designing the object as a whole. The reasons are as follows. The existing SNiP does not regulate the issues of static calculation of structures of buildings and structures. Their requirements are usually reduced to ensure that the designs are strong, hard, stable. It is obvious that such a state of structures can be ensured by using various calculation methods. Before the advent of computers, the calculated models of complex designs and calculation methods were used very close. In most cases, static calculations were not made at all, and the design was performed on the basis of analogues. This is especially true for common objects of civil construction: few – and medium -story residential and public buildings.
