Initially, you need to remove and take out all the furniture and plumbing devices to prevent them from unforeseen deformation and the release of space. If you need to remove the old tile, this must be done extremely carefully so as not to deform the partitions.
Each partition should be marked in terms of the volume of the whole element. If half are from below, then first you need to lay a series of whole components. As a support for the initial row, which does not allow components to slide, you can use bars or a metal profile. It is worth remembering that the support must be made even, it is better to mount it before installing the tile in the room. Glue the material on a special mass. At the time of its preparation, you need to remember the proportions of dry solution and water. When the substance is ready, you can start work. You can purchase this material on the BrandSplitka/ Cheap website. The choice of goods is huge.
You need to do everything from the corner. Using a spatula, you need to apply and leve a little mass to the partition. Then you need to apply the same mass to the material using a special spatula with cloves that leave the furrows on the surface of the substance. So the material will remain the optimal volume of glue, which will improve installation. The first element must be glued and pressed a little. Between the components, you need to install plastic crosses, and from the side of the floor or partitions – wooden spacers. Now it will become easier. Continuing the installation, do not forget about the spacers and do not apply too much glue. It must be remembered that the corners of the material do not “be sunk”.
The tile is cut by special equipment, because with other tools there are uneven edges. Before cutting the material in the front area, you need to mark the incision. You need to make a couple of quick movements, and then hit the cut line. By laying the material in the bathroom near the rounded holes of the water supply, you need to use a certain drill with a circul.